Answer / arun/ i&c design engineer

Instrumentation & Control engineering is the most
interesting and one of the most important engineering
stream in a process industry. Most of us have studied the
process of purifying petrol, diesel, kerosine from crude
oil, using distillation.....but for the right product with
right charateristics the process measurement is required in
real time for analysis and for a safe execution of the
same, the process should be under control. This basic
factor gives birth for the need of a engineering stream
called Instrumentation & Control.
so a instrumentation engineer must know about the basic
laws of physics, based on which each and every instrument
works, knowledge in electronics and microprocessors is must
to understand the modern day advanced measurement
techniques and control engineering. knowledge in
Matallaurgy and basic chemical properties will give u an
upperhand.
Konwledge on field instruments, basic electrical
engineering, wiring standards, control logic development,
control systems like DCS, PLC, communication protocols like
RS 232, 442 etc, profibus, control net, and upto the latest
foundation field bus concept, safty features, atleast
outerskin process knowledge...all these are required but
not limited to, for an Instrumentation engineer.

Answer / joseph

Instrumentataion ENgineer must need these things,
First of all,An engineer to know about how can
we prepare the document of one project(MS-word,MS-excel,MS-
PP) and communication for speech.
Basic Knowledge of Power Plants and Oil&Gas
industry.
Need to know about interior of Measurement
systems of units and Automation(Plc).

If u read Industrial Applications of
instruments ,its very useful for Constructional instruments
job also.
If the student have the capacity,must know
about basics of Autocad to draw atleast 2d.

how the flow rate is measured from a pipe with the help of pressure?

1 Answers  

---

What are the types of valves?

0 Answers  

---

how to calibrate control valves & power cylinders & ultra sonic level transmitters

0 Answers   ABB,

---

what is meaning of static pressure

4 Answers   Ambuja,

---

Can 2 transmitters be connected to Integral orifice meter taps? Does an integral orifice comes with 2 set of taps?

1 Answers  

---

What is output of Thermocouple at 25 deg c

10 Answers   TATA,

---

What is mean by trim?

5 Answers  

---

In 2 wire transmitter 1 wire is used for power and other is used for signal( 4-20)ma In 4 wire transmitter 2 wires are used for power and 2 wires are used for signal (4-20)ma . but my question is "what is the criteria or parameters we have to consider while selecting these transmitters for eg( distance, safety zones etc.

1 Answers  

---

i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.

0 Answers   OEG,

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers   Process Control Technologies,

---

what is Mv with respect to temprature in thermocouple

2 Answers  

---

how to connect 3 wire 4-20 mA transmitter in Plc system PLC system and how explain how the measuring data communicate with plc system.

1 Answers  

---