Why power factor does not occur in DG set ?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / ramya

6 Answers
10084 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why power factor does not occur in DG set ?..

Answer / rahul

RAMYA .... that was a gud ans, but seems to be incomplete.

Rahul
ABB,UK
Design eng.

Is This Answer Correct ?

5 Yes

0 No

Why power factor does not occur in DG set ?..

Answer / deepak mishra

in case of dg set there is no load for which it can develop lagging or leading power factor .it only produces power supply to be transferred.so its not virtue of dg .

Is This Answer Correct ?

1 Yes

0 No

Why power factor does not occur in DG set ?..

Answer / shafiullah khan

Actually Power factor depends upon the load connected to the DG Sets,If the laod is resistive ,P.F will be 1,if inductive P.F will be lagging while in case of capactive load it will be leading.

Is This Answer Correct ?

0 Yes

0 No

Why power factor does not occur in DG set ?..

Answer / ramya

thnks for your advice Rahul

Is This Answer Correct ?

0 Yes

1 No

Why power factor does not occur in DG set ?..

Answer / viswanath

Ramya you are answer is good

Viswanath
Electrical ENGG., U.K

Is This Answer Correct ?

0 Yes

1 No

Why power factor does not occur in DG set ?..

Answer / ramya

because DG set its not act a load its producing power, its
not getting power ,so power factor occur only in loads like
motors,load bank ,any other suggestions welcome .

Is This Answer Correct ?

4 Yes

11 No

Post New Answer

More Electrical Engineering Interview Questions

what is the difference between capacitive and resistive voltage divider?

0 Answers

why ac generator ratings in kva only why not kw ????????????? ?

7 Answers

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers

what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me

0 Answers Escorts,

what is power plant?

2 Answers

What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?

0 Answers

Reversal of corrent feature in MCCB- What is reversalof current -explain broadly.

1 Answers

What will be the output of t/f supplied with DC sourse?

2 Answers

For a DY11 lighting Transformer on primary side whee to connect fourth lead? from nuetral or from ground?

3 Answers Sabic,

different types of electrical cable?

1 Answers Green Power,

11 KV Power cable end earth connection insulation got burned wht is the reson pl give the resons

2 Answers

does frequency affects the load? if yes elaborate it.

1 Answers

For more Electrical Engineering Interview Questions Click Here