Answer Posted / shafiullah khan
Actually Power factor depends upon the load connected to the DG Sets,If the laod is resistive ,P.F will be 1,if inductive P.F will be lagging while in case of capactive load it will be leading.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between surge protection capacitor and surge arrestor
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
what happen if the parallel generator phase angle shift by 1 degree in manual mode
Why compensation is necessary in feedback control system?
How do I calculate/select Droop CT ratio for various capacity of generators?
State thevenintheorem?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
what is the difference b/w absolute encoder and incremental encoder?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
Power Factor Correction Panel (Manual & Automatic)
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
