Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramya
because DG set its not act a load its producing power, its
not getting power ,so power factor occur only in loads like
motors,load bank ,any other suggestions welcome .
| Is This Answer Correct ? | 4 Yes | 11 No |
Post New Answer View All Answers
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
are there rmu for 3 transformer?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
Define what is the function of anti-pumping in circuit breaker?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
What are safety device in vcb and acb?
1.what is mean by 8/20 micro sec waveshape
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
STATE USE OF ARC RUNNERS & SPLITTERS ?
what is level 2 automation?
why the check zone and main zone are used for Busbar Protn. scheem?
