We have 5 Distribution sections with variable loads&We have
3 Gensets(500kva,380kva&250kva) our total load is between
400kva to 600kva. so how could we connect 3gensets.
No Answer is Posted For this Question
Be the First to Post Answer
What is the basic rule for block diagram reduction technique?
What is the difference between single phase, 2phase, and 3 phase motors?
i have ht transformer of 142 kva with air cooled facility,having secondary voltage 7850volt, and secondary connected full way bridge rectifier .i faced the problem repeatedly that transformer one coil and rectifier diode of two phase was burnt two times. i checked all the secondary ckt. no any short ckt found,then what will be the cause side
2 Answers Modern Terry Towels,
what is differant beetween overload current and phase current?
is the secondary voltage of current transformer greater than primary voltage,,,,,,,,] give the example with ct burden,current ratio,and primary and secondary side voltage?
how much power consumed by 1.5 ton capacity split A.C in 1 hour
what is different between synchronous & asynchronous motors
what is hystersis loss?
what is Fault level? why it is calculated? how will u decide same for our plant?
How can calculate ups battery back up time?
25 Answers Cisco, Cooper, Pronet, Wipro,
How to test IR testing & magnetic balance test
is there any pottential in neautral?