Answer / denzel101

Fault level is a value of fault energy realesed under fault
conditions.for example if we have

A 20MVA 66/11KV with a 5% impedance.

Maximum fault MVA will be

20MVA/0.05 = 400MVA

Answer / sandeep

Generally Fault current is 20 times the actual current

what is the temperature rise test? explain in brief.with formula.

1 Answers  

---

if the synchronizing b/w generator and busbar not complete and we close the out going circuit breaker of generator then what happen ?

4 Answers  

---

Hi, what is the temp of bus bar.

1 Answers  

---

In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?

0 Answers  

---

testing of Vector Group – YNaoD II

0 Answers  

---

What is UPS?

14 Answers   HSL,

---

How many types are using in 220kv/400 kv swith yard

0 Answers  

---

what time should we set to come on star contacter in stardelta starter?and for what reason we hav to set such time delay range?

2 Answers  

---

1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?

0 Answers  

---

An 11kv system consisting of an underground cable to a sub station about 300 meters away was shut down for about 10 hrs. On energising, it tripped off on earth fault about 10---20 mins later 6 times but since than it is not tripping.its already 3 weeks now. The SPAJ was found to be fine. what could be the cause.No test had been done to determine the cause of the trippings till now because of demand.

2 Answers  

---

What is the effect of solar radiation on the design of an Isolated Phase Busduct?

0 Answers   Exide, Punj Lloyd Ltd,

---

why capacitive load is not used in routine life????any reason is there ??????

0 Answers  

---