When semiconductor fuse does save thyristor in each cycle
of conduction? Why under voltage setting keep less in SPRS
and more in DC drive?
No Answer is Posted For this Question
Be the First to Post Answer
How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
kindly tell me how the load on generator increase by just increasing the fuel of prime mover, as if for exampple 20 MW gen set is synchronized the load ramps from zero to 20 MW gradully and during this procress only fuel of prime mover increases. Which thing determines the load on generator with respect to fuel
In ac which gas will be use?
what should be the motor rating for pumping water for house hold use from 60km far lake and what formula is to use please tell me
what do you mean by earth fault in transformer?
why the name trunking bus PT
Why the colour of insulator is always is chocolate in colour?
Transmission through a short line depends on
Why the CT Secondary is rated as 5A generally?
ups battery design formula
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)