What is the selection & Designing procedure for
DG/Transformer
Answer Posted / r.baskar
Selection of transformers = Maximum Connected load *
loadutility factor of the industry(0.75 is the thumb rule)
For DG Maximum capacity of the Motor being started at
DOL*2..
Am i right ..?PLs clarify ....
R.Baskar
Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
how to calculate fault level?
When are the directional relays used?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Define what is the function of anti-pumping in circuit breaker?
In parallel operation time both NGR’s close or not close if both close what will happen
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
Why is the air gap between the pole pieces and the armature kept very small?
What happens to voltage when current through the inductor is constant?
can u tell me the promotion from oiller to enginer
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15