Answer / omar aziz

Every power transformer has a vector group listed by its
manufacturer. Fundamentally it tells you the information
about how the windings are connected (delta or wye) and the
phace difference betweent the current and voltage. EG.
DYN11 means Delta primary, Wye Secondry and the current is
at 11 o clock reffered to the voltage.

Answer / rajendran

The angle in the specification indicates the phase
difference between primary and secondary quantities and not
between cureent and voltage....

Answer / raj

the primary leakage flux to the secondary leakage flux .
when the secondary currents increase .the primary leakage
flux increases and reactance increases in power transformer
the vector sum of angle is lags behind the voltage.

Why is the earth pin in a 3-pin plug the longest and the thickest?

10 Answers   IBM,

---

How are calculated the aluminium busbar cross section area?

2 Answers  

---

what about electrical pannel.? What is meant by plc pannel.?

0 Answers   TATA,

---

For 132 KV line, PT or CVT which is prefered for measuring & protection? is there any IS or IEE standard available?

1 Answers  

---

will a bulb glow connected to two phases of a delta connection?

6 Answers  

---

WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??

7 Answers   Reliance,

---

Could you measure voltage in series?

0 Answers  

---

what is the difference between neutral and earth

0 Answers   LOreal,

---

What is difference between start imitation and start interlock for 3 phase motor protection ?

0 Answers   Siemens,

---

In the diesel generator if there is an AVR (auto voltage regulator) gone faulty, in this condition is there any way to generate the voltage from the alternator? I need a brief explanation can you please help somebody

1 Answers   Vodafone,

---

What is cable gland,why does use for?

5 Answers   ABB,

---

Explain thin film resistors and wire-wound resistors

0 Answers  

---