IF WE SELECT THE 60H FREQUENCY IN INDIA WHAT WILL THE GOOD
AND BAD EFFECT ?
Answers were Sorted based on User's Feedback
Answer / sagar hingmire
Dear Friends,
If 60 Hz frequency is used it will be good for speed
related machines as Ns=120*f/P Speed of motors will get
increased.
Considering all eqipments having winding core,its winding
core heating will get increased as Eddy current loss is
directly praportional to frequency & Hysterisis loss is
directly praportional squre of the frequency.
Is This Answer Correct ? | 19 Yes | 0 No |
Answer / shahulsnfa
the speed of the machines and the swithing speed of the
appliances will be good but the generation, transmission
and distribution of power will become critical to replace
the existing system.
Is This Answer Correct ? | 11 Yes | 1 No |
Answer / shivam
size of transformer will reduce but we will have 2 change
whole power system
Is This Answer Correct ? | 5 Yes | 2 No |
what is tpmo switch
what is ignition?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
0 Answers TNEB Tamil Nadu Electricity Board, Vestas,
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
we hav seen in electric engine of trains only 1 wired slidng conecctn is there frm ovrhead line,howevr to complete a ckt in dc postv n negtv two conection has to b there...so where is tht negative is been connectd or where it is grounded...?
how to select a cap,when a fan is required 2.5 micro ferad cap,then how we know about 1 hp motor?
Can i connect all earth pits in ring system..., And wat IS 3043 says...please help me
What is the most accurate way of testing ELCB?ELCB is better than RCD?
What is the difference b/w RMU & substation
what is mean by flux
what is MCCB?
hi frnds.....anyone get any reply from HPCL. I HAVN'T.....B,COS written will b on FEB 17 th.