Answer / amit sonmale

power factore is The Ratio Of Loss Of Inductive Load
Between true Power And Aperant Power Also It Can Define In
Cosin Angle Between Voltage And Current.

Answer / sanjay

Power factor is cosin angle between voltage and current.

Answer / bindu

It is the ratio between active power and reactive power.

Answer / shashidhara tm

It is an indication of what fraction of the sending end VA
is actually converted in to energy Like heat, torque,
etc......... either useful or otherwise... It is
numerically equal to the ratio of Active Power-P to
Apparent Power-S.
Incidentally, this quantity in Sine waves is equal to R/Z..
or Coa(angle between v and I)....
But in circuits with non-sinusoidal waveforms of v & i, it
is to be found by P/S...

Answer / sagar

power facor means ratio of true power(kw) and apperant(kva)
power.

Answer / simon

P.f=Real Power/Apperent Power OR V.I.CosPie OR Resistance/Impedance OR R/Z.

Answer / thamizh

IT CAN BE DEFINED AS THE RATION BETWEEN RESISTANCE AND IMPEDANCE

COS0=R/Z

200-100/1-1A – Transformer Knee point voltage

1 Answers   AAPT,

DG SET BLOCK DIGRAM

0 Answers   L&T,

In an LT pole, the line voltage is 415V. How is it converted to 230V into the house via the service cable?

10 Answers  

What will happen if the voltage in my house drops from 220V to any lower voltage?

0 Answers  

Why alternators are designed at 0.8 pf lag?

3 Answers  

Which type of gas used in cylinder (VCB)?????

15 Answers   ICSA,

what is PWM in IGBT and how it works for drive.?

0 Answers   BRG,

what is the maximum current rating in india for home?

3 Answers  

Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?

0 Answers  

low voltage means how much voltage? extra low voltage means how much voltage? medium voltage means hos much voltage? high voltage means how much voltage? Ex: low voltage - 1volt to 240volt like this

3 Answers  

what will happen if a 3 phase motor is connected to a single phase circuit and vice versa?

3 Answers  

How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?

0 Answers