can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.

1 Answers  

---

For an 100kw generator, only 50kw of load is connected. Will the generator generate only 50kw or 100kw. If it generate 100kw what happens to rest of the 50kw. What happens if we connect more than 100kw of load?

2 Answers   L&T,

---

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

0 Answers  

---

What's an AVR? What's its purpose in Generators?

4 Answers  

---

at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)

0 Answers   Ebrahim Textile, Siemens,

---

please send me privious exam's queation papers of section engineer(electrical).

0 Answers   RRB,

---

if one potential missing in energy meter , how much % slow the energy meter?

1 Answers   NTPC, SK,

---

how techometer works and how it will be connected above the flywheel in dg system

1 Answers  

---

What is an automatic controller?

0 Answers  

---

High Voltage out door substation-annual maintenance, things to be considered

1 Answers  

---

what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY

0 Answers   L&T,

---

Why does the rotor rotate?

0 Answers   Elin, OPTCL,

---