Answer / ganesh shelke

if 3 phase motor connected to single phase supply ,single
phasing happen in motor and motor will take high current
.3pphase motor require 3 phase supply for producing roating
magnetic field.so do not connect 3phase motor to single phase

Answer / karthik

a 3 phase machine is used for high power application and the rotating magnetic field is created by the 3 phases hence when it is connected to a single phase supply we will not be able to create a rotating magnetic field unless the field is connected along with a capacitor or inductor to create a phase difference. but whena single phase machine is connected because of the inherent phase lag between the various phase of supply.

Answer / n.k.singh

If single phase 230 V is available then motor will not
start.
If single phase 440 v is availbale then also motor will not
start.

If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?

0 Answers  

---

what is the diff between earth leakage relay and earth fault relay?

7 Answers  

---

v=I*R, i.e V is directly proportional to I. now P=V*I. so V=P/I. thus v is inversely proportional to I. so what is the correct one? If both are correct than for which kind of condition this 2 differ

3 Answers  

---

why the emf of a cell more than the terminal voltage when the cell is delivering current?

4 Answers  

---

How much ph is maintained of water resistance starter for slipring induction motor ?

0 Answers  

---

Is there any local or International standards that prohibit the installation of earthing pit in the planters area where the earthing pit is subject to continues soak in water?

1 Answers  

---

how is positive, negative, zero sequence is happen.. how is effect on 3 phase system

0 Answers  

---

What types of I/O have you designed? What were their size? Speed? Configuration? Voltage requirements? Process technology? What package was used and how did you model the package/system? What parasitic effects were considered?

0 Answers  

---

when we conduct high voltage testing why milli amp. is required?

2 Answers  

---

how much current will be drawn by 3 phase, 415v, 50 hz, 20 ton central ac

3 Answers  

---

what is different between grounding and earthings?

4 Answers  

---

what is the need of representing AC power in sinusoidal waveform? why not in square or rectangular etc...

8 Answers   Lanco,

---