Answer / abdul salam

Power factor is the quotient of KW to KVA, in this
perticular case when PT is missing in one phase then the
voltage which is seen by the meter will increase as a
result KVA will increase and hence low PF.

Answer / dave.vimal

When One phase PT missing. HT consumer is always used three
phase load . This time consumer is not using load but
capacitor bank is on . so power factor is low and lead

without any theoretical calculations, can u approximately tell the current rating of a motor(above 30hp)working at 415VAC.

7 Answers  

---

Explain why the Voltage drop will happen in 3 Phase line?

3 Answers  

---

what is meant by moulded case circuit breaker ?

1 Answers   ABB,

---

What is load curve?

2 Answers  

---

why induction motor take more current when motor start time and this current take for 1 hours when motor is start.

2 Answers  

---

Why is ignitor used in sodium vapour lamp

2 Answers  

---

If single phase voltage level is 230V than why three phase voltage level is not 660V ?, but it is only 440V.

16 Answers   BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp,

---

Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة

1 Answers   HMK,

---

What is the RMS Value. Please discribe in detail

14 Answers   Bhel,

---

What are the Safety Steps While Inspection the LT Panel.  

1 Answers  

---

what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..

1 Answers   HPCL,

---

what is vA rating and class of a ct.

1 Answers   L&T,

---