Answer / brijesh k pal

the inside diameter of pipe,density,velocity & specific
volume with corrosponding pressure & temp are required to
get the mass flow rate of steam

Answer / khan

q=cvp,the steam folw is represented by "q" and where in the equation c is constanat with v and p are velocity of the steam and p is presssure.

what is use single seated and double seated valve?

2 Answers   Doha Petroleum Construction DOPET,

---

Whatis the reset ofset and control system in instrumentation

0 Answers   Asyad International Company, CAE, Sugar Factory,

---

centrifugal compressor interlock? Tell me the parameter at which compressor will trip

0 Answers   Cairn,

---

What is the basic difference between 2 Wire, 3 Wire and 4 Wire RTD

2 Answers  

---

What is the role of Integral in pid control?

6 Answers  

---

sir, give me placement papers and interview quistion of birla group company of copper.

0 Answers   Birla,

---

if we open the inlet of an air regulator ,how it will affect the out put of regulator? (out put of regulator is using to operate an on-off valve.it is an air to open valve,and valve is in open position.my doubt is air regulator will hold the valve in open or not,if there is no consumption or leak in regulator out put side ,we only loose the input pressure.)

4 Answers   Asian Paints,

---

Is it possible to drill additional gland hole in EExd or EExe JBs? What are the points to take care?

2 Answers  

---

What is difference between reset and initialization in system.

1 Answers   Marafiq,

---

Explain the difference between the types of input variables plc?

1 Answers  

---

How do bending tubing provide better measurement than using tubing fittings such as elbows?

0 Answers  

---

what is the essential difference between DIODE and SCR in term of application.

2 Answers   ADMA OPCO,

---