Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Main principle and formula for the steam flow
compensation?
- 2 Answers
- 11987 Views
- I also Faced
- E-Mail Answers
Answer Posted / brijesh k pal
the inside diameter of pipe,density,velocity & specific
volume with corrosponding pressure & temp are required to
get the mass flow rate of steam
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
I need to know steps to Calibration Valve Guard......
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What is the difference between mmwc and mmwg?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
what is the calibration procedure for transweigh make weigh feeder?
if my flow is 20000 m3/h than which range of DPT i have to use????
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
What is Predictive Maintenance
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
Give Detail information about plc,dcs,and scada system?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
what is wave length were using ?
What is loop1 and loop2 in MTS LT?
