Answer / s,jude finney

amount of copper used for conduction is less in 3phase for
the same amount of power in single phase

Answer / phanendra babu

there are so many reasons
1.generation is 3ph. so convertion is difficult
2.losses will be more in single phase system
3.equipment cost will be increased
4.copper cost increased for example for 3ph sys 3wires are
enough to transmit but for 3 single phases 6 wires are req.

Answer / gunasekaran

power regulation is good for 3phase system.

Answer / guest

The power generation in india is 11kV 3phase,50Hz & vch is
economical (as per standard)
After genration v have different voltage levels for
consumers(Transmission to Distribution).
in distribution the voltage is steepped down to 440v
because different loads r there for domestic and industrial
needs.
so v can take tappings for any phase for consumers..

difference btw neutral and ground?

2 Answers   ERG,

---

how to check three phase motor torque value?

0 Answers   Apollo,

---

i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.

0 Answers  

---

12.5 tons a/c is their how much kva generator can recommend to the customer.

0 Answers  

---

In case of a synchronous generator carbon brushes, some brushes expire before the others. Why is so? When all the brushes are installed at the same time, why don't thee expire at the same time?

1 Answers  

---

wich type of cable is selected for wiring of 20hp motor?

5 Answers   Alchemist,

---

how can we choose the size of road crossing pipe for power cables

2 Answers   DLF,

---

What is bushing?

4 Answers  

---

what kelvin's law ?

0 Answers  

---

Mathemetical Relation Between KWRH and KWH?

3 Answers   UPPCL,

---

Why are lt windings placed near the core?

0 Answers  

---

How the over load setting for HT Motors calculated-provided in Numerical Relay

0 Answers   Damodar Valley Corporation,

---