how to calculate bearing width

0 Answers  

---

Categories >> Engineering >> Mechanical Engineering Suggest New Category Question Asked @ Answers Views select what is advantage of hllow shaft over solid shaft aprt from material saving? does hollow shaft absorb more vibration than solid shaft? 0 5 wat is the meaning of cop of wet suction and dry suction????? 1 171 What is the difference between an axle and a shaft? reply soon frnds........ 4 260 16 inch = 1 ______________? 2 124 What are the steps taken in troubleshooting of a machine e.g extruder ME 0 26 What is a seal? ME 3 133 what is the mean of b.tech? 3 167 what type of pump 2 63 what is differance between ball screw and lead screw ? Amtek 1 86 What is the units of surface tension and also dimensional formula? RRB 3 218 What is meant by cigarcone? RRB 3 120 I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons 0 24 why steam power plant is more popular than gas turbine plant? ME 3 304 what is EEE in thermodynamics????? ME 2 223 what is the practical use of ENTROPY? JSW 4 282

1 Answers  

---

please send the last 5 years {{{JUNIOR ENGINEER GRADE II - MECHANICAL RRB CHENNAI}}} TECHNICAL question papers

0 Answers  

---

I want technical questions of previous reqruitment examination

0 Answers   Jindal, RRB,

---

Explain the difference between blower and fan?

0 Answers  

---

---

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers  

---

Can you explain,what is entropy?Also tell us what happened in terms of ENTROPY when you give heat to a sealed tube containing half of water?

5 Answers   IFFCO, NTPC,

---

what is the reason? if centrifugal pump is not discharge the water or not suck the water in running condition.

6 Answers  

---

sir i am working in CIM Technologies , AS DESIGN ENGINEER, I WANT TO PREPARER FOR INTERVIEW TO THE DESIGN PLEASE SUGGEST HOW TO PREPARE FOR INTERVIEW

0 Answers   HAL,

---

distinguish the knock phenomena of ci and si engine?

0 Answers  

---

What is bearing & How many types of bearing ?

2 Answers  

---

What is a combination thrust and radial bearing?

0 Answers  

---