boiler fusible plug melt down, normally melt down due less water or feed pump fa

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

Question Posted / masuria

1 Answers
2803 Views
I also Faced
E-Mail Answers

boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there ..

Answer / pranav

No it won't melt. There is no chance that the temperature of the water in boiler may go above the melting point of the fusible plug.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

Stress produce strain or strain produce stress.....?Explain?

9 Answers Behr, Bhel, ONGC,

wt is bulk mod

2 Answers TCS,

What are the uses of windmill?

0 Answers

What are the some examples of a periscope?

0 Answers

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers

What materials are used for engine propeller?

0 Answers RRB,

please send jindal steel and power model question papers

61 Answers Jindal, Jindal Steel and Power, MeritTrack,

what is the efficiency of horizontal & vertical feed water heaters?

0 Answers

what is the different between tube and pipe

4 Answers Tata Power,

how much standard used in Piping system

1 Answers Greenko,

twist drill angle

9 Answers DRDO,

Why gas containers are mostly cylindrical in shape?

0 Answers

For more Mechanical Engineering Interview Questions Click Here