Answer / mukhesh

power factor is cosine of angle b/w voltage and current
power is combination v&i
leads mens curnt leads voltate by 90d bcze cap means is
measure 2 dile plates in dieletric medium so leads in
inuctor dieletric medium is not tger so lags

Answer / kevin

it is the relation between voltage and current . were in
capacitor is used the current lead the voltage . and in the
current is lagging behind voltage.

Answer / 89

in capacitor current leads the voltage due to the usage of
dielectric medium in it but not for an inductor

Answer / umesh kumar

Power factor:- Power factor is the cosine angle difference
b/w voltage and current. current is always leading or
lagging if ur P.F is not unity, so to maintain the power
factor u have to check ur load circiuit.
Suppose if ur circuit have more Inductive load then it
will absorbs extra power and take the current lagging to
volatge.
And if we have connected Reactive power in the circuit then
it will generate extra power and it will take the current
leading to voltage.
if we have ballanced the circuit , balancing means if
inductive load is equal to capacitive load then the voltage
and current will be on the same phase and power factor will
be unity.

What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning

0 Answers  

---

HOW TO MEASSURED THE AMPS RATING FOR SUITABLE CABLE SIZE?

4 Answers  

---

two generator runnig with parallel but only one NGR on And one off Why

1 Answers  

---

What is the difference between Earth Fault protection & Neutral Protection

1 Answers  

---

what should be the megger test report for 11KV cable when meggered with 5KV megger , what is the resistance value we should get

7 Answers  

---

In Panels Main Incomer considered should be TPN or FP?

2 Answers  

---

what is ground fault in ACB?

0 Answers  

---

difference between the applicability of nortons and thevenin theorem

0 Answers  

---

Why the starting current in Induction Motor is very high as compared to normal rated current ????

6 Answers   Essar,

---

Why two main buses and one transfer bus scheme not using for 400kV switchyard

5 Answers  

---

How to select the different contactors ( starter combination) for different AC motors? what about fuse cappacity 4 different motors too?

2 Answers   Equate,

---

how to work current transformer and potential transformer

1 Answers   Adhunik,

---