Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by leading or lagging power factor?like in
capacitor power factor is leading and in inductor power
factor is lagging
- 4 Answers
- 10615 Views
- I also Faced
- E-Mail Answers
Answer Posted / umesh kumar
Power factor:- Power factor is the cosine angle difference
b/w voltage and current. current is always leading or
lagging if ur P.F is not unity, so to maintain the power
factor u have to check ur load circiuit.
Suppose if ur circuit have more Inductive load then it
will absorbs extra power and take the current lagging to
volatge.
And if we have connected Reactive power in the circuit then
it will generate extra power and it will take the current
leading to voltage.
if we have ballanced the circuit , balancing means if
inductive load is equal to capacitive load then the voltage
and current will be on the same phase and power factor will
be unity.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
How PADO software increase the efficiency of power plant?
Write a note on Treatment for electric shock.
what is diff. between earthing grid,earthing mess, earting grid?
What is inverse definite minimum time lag relay? Where is it use?
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
If rotor works in clock wise what happens
what is earth pit , how we can measured it, what earth rods reference
wat is the first thing dat is needed, 2 lay a cable in some area??
