What is expansion of SMART Instruments? And What is it?
Answers were Sorted based on User's Feedback
Answer / k.thirunathan, ntpc ramagundam
SYNCHORISATION MODULATION ADDRESSABLE REMOTE TRANSDUCER.
Is This Answer Correct ? | 8 Yes | 23 No |
Answer / satish patel, bilimora
square memory addressable remote transducer
Is This Answer Correct ? | 1 Yes | 20 No |
I want to install analog type, flange mounted gas flow meter (line size - 2"), for CNG flow measurement.Kindly give some details of flowmeter or suppler name, available in India.
what is interlock system and why we use of this?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the formula to convert mv to temperature in k type thermocouple?pls simply elaborate? I got one ans.it is Temp=mv×25°+atmospheric temp,but here what is 25°,i confusef ,so pls????
what is the difference between Ethernet unmanaged and managed Switch?
How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible
What is Process portal A(PPA)?
What is the purpose of the analyzer in petrochemical plant?
0 Answers ENI, Lakshmi Machine Works,
We are used ABB 800xa 5.1.please tell me how to instrall this.
If we interchange HP and LP tapping in drum level measurement and reverse LRV & URV correspondingly.What is the difference between the normal tapping(HP,LP) and reversed tapping(LP,HP)?
Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???
What are securities of turbine?