Answer / Niraj Kumar Sharma

To calculate the flow rate (Q) with the given specifications, you can use the following formula: Q = C_d * A_o * sqrt((2g * h) / (b^2)), where C_d is the discharge coefficient, A_o is the orifice area, g is the acceleration due to gravity, h is the height of liquid column above the orifice, and b is the bore diameter. To find the orifice area, use the formula: A_o = π * (b_o/2)^2, where b_o is the orifice diameter (which can be calculated based on the given orifice size using conversion factors). The discharge coefficient can be found using a nomograph or empirical equations.

Why the Proximitor supply should be Negative voltage? Why should not we give Positive voltage to the Transducer?

6 Answers   Moser Baer,

---

How will you measure surface temperature of SUN?

2 Answers   GAIL,

---

draw the characteristics of chebyshev filter

0 Answers  

---

1.how can calibration temperature transmitter and flow transmitter? 2.

0 Answers   Gulf Jobs,

---

can you suggest good traning institute in instrumentation ? (in automation, or designing)

5 Answers  

---

Is there is a device to convert mechanical energy to electrical energy

4 Answers  

---

why r using 250 resistances

6 Answers   Sabic, Samsung,

---

what is function of PLC, and how is it work , explain with difination

1 Answers   Bapco Bahrain Petroleum Company,

---

What is transducer

4 Answers   IFFCO, Jindal,

---

control panel design guidelines

1 Answers  

---

what is diff between the centrifugal and reciprocating

2 Answers  

---

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

1 Answers   Gasco,

---