Answer / sareer ahmad lone

Star connection is that connection from where we can take
the neutral point.If you take three coils in a transformer
similar ends are joined together to form a common point
which is called a neutral.We can earth the neutral point.
Normally for bigger transformers like 66kV or more the
connection is star/delta,and the cost is less because the
higher the voltage the more the insulation you have to
use,so if you use a star primary you can degrade the
insulation towards the neutral point,then using less
insulation.Hope the answer is correct

Answer / satya

star winding is nothing but the connection of three windings
at one point with similar ends

Answer / sankara babu

star connection is defined as all the conductors connected to a common point is called star connection .
for the higher voltages we are use the star connection due to the insulation problem.
for higher voltages we use the star-star connections.
on secondary side of transformer we always use the star connection with ground confirm

Answer / ashok kumar

in distribution the primary winding is connected in delta
connection and secondry winding is connected star
connection, because to follow the kcl loop.

What is substation?

5 Answers   KSEB, Neolite,

---

DIFFERNCE BETWEEN DCS AND PLC? HOW IT WORKS?

0 Answers   Essar,

---

watt meter have 4 terminals what there name??? and what theses 4 terminals indicates ?? and why 2 terminals are short circuited??

1 Answers  

---

I NEED RRB CHENNAI (JE ELECTRICAL) QUESTION PAPER FOR LAST 5 YEAR AND I NEED RRB (JE ELECTRICAL) SYLLABUS.PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in

12 Answers   DFM, Hindustan Unilever Limited, JE, Pace, RRB,

---

how to calculate multiplying factor with ct ratio 400/5

1 Answers   KBPL,

---

i need to connect fact device(any one from following upsc,sssc,svc,statcom and tcsc)in 14 bus system....by using MATLAB psat software....if i connect these fact devices,i will get some error as "virtual error"...i cnt rectify this error.if anybody know that how to work in psat,pls help me to rectify this error.... or send mail me to, viki0607@yahoo.co.in

1 Answers  

---

our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage

4 Answers   Gannon Dunkerley,

---

why we are having many type of vector group in the transformer ,what is the use of it?

2 Answers  

---

I want to know the standards for earthing system as per IEC, BIS & IEEE.

2 Answers  

---

How do you know when the battery is fully charged?

6 Answers   ABB, Pricol,

---

If ac 230volts inputsupply to full wave rectifire what is D C output voltage.

3 Answers  

---

Do I need a special Transformer to put 240 VAC 3 phase into it and and get 480 VAC 3 phase out of it to run a machine? Or, do I just use an ordinary step down transformer and step up the voltage? Thanks

2 Answers  

---