If the capacitor feeder is switched ON without any load, is there any display in

If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the incomer?

Question Posted / john.c

3 Answers
6453 Views
RTD, Welspun, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the ..

Answer / karthik_elec

yes the ammeter will show some small current value, if the
capacitor fully charged it will not take any current

Is This Answer Correct ?

3 Yes

0 No

If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the ..

Answer / vaseekaran

YES IT WILL SHOW SOME READING AS THERE IS NO LOAD THE CAPACITOR ACT AS A LOAD.BUT WHEN THE CAPACITOR IS FULLY CHARGED THE CAPACITOR IS BY PASSED SO THERE WILL BE NO READING IN THE METER.

Is This Answer Correct ?

3 Yes

0 No

If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the ..

Answer / raju

Yes, some current will display if capacitor bank connected.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why cannot we use a freuency more than 400hz is used in aircrafts?

1 Answers

how to determine ct ratio in ht vcb?

0 Answers Techno Engineering,

why surge suppressor in vaccum circuit breaker and it is only in motor feeder why not in tranformer feeder?no surge suppresor in ocb in motor feeder?

1 Answers IOCL,

What are the technical reasons for soaking transformers for various times before allowing them to pick load after a fault ?

4 Answers GE,

how to reduce earth to neutral voltage?

8 Answers Field Gun Factory,

why dc is used in control circuit for mv & hv switchgear instead of ac

0 Answers

Even motor protection, why motor burn out ?

1 Answers Indorama,

Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.

0 Answers TATA,

IF WE SELECT THE 60H FREQUENCY IN INDIA WHAT WILL THE GOOD AND BAD EFFECT ?

3 Answers

will the power consumption remains the same when speed of the fan cnanges??if so y??

2 Answers

What will happen if 2 phase supply is given to 3 phase motor?

4 Answers ABC,

If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?

0 Answers

For more Electrical Engineering Interview Questions Click Here