Answer / krishna

we are genralley used tansformers secondary side star if we
take the load that time any phase cut or unbalance its
possible that s why weare useing in mcc's in neutral ct
also

Answer / shal

Yes, negative current will flow

Answer / geno peter

well, current meeting at a point is zero, take the case of
a star connection, where the neutral is possible. in the
neutral point current is zero

Answer / mrudang

No

Answer / kaarthikrt&c

hi to all n Abc, let the system be in balanced
condition,all current path circuits gets closed at
neutral,let us consider a heater coil 1 end is connected to
phase and another to neutral, according to ur view in
neutral current flow is not there, my question is how u get
a closed path for this current? (dont compare with 3 phase
neutral/Transf. or motor)

Answer / geno peter

well , The current flow will be maximum in the neutral
added the voltage is zero

Answer / sivasamy83

The circuit is closed through Neutral...but the current is
Zero.....That what it's called Neutral.....

As per questation where ever the path the current can
flow.....

what is the difference b/w ATS and HTS?

0 Answers   Mikano,

what is the meaning of vcc

0 Answers  

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers  

tell 2 reasons for why only copper is used in domestic wires& only alluminium in transmission lines ?

10 Answers   ABB,

What is miller crystal oscillator? Explain its operation?

0 Answers  

how starting current in motor is reduced in case of motor in star connection.

4 Answers   Adhunik,

how to calculate the tarriff for an industry whose kva demand is 10 mva

0 Answers  

IDMT relay are mostly used for protection against..??? 1)Earth Fault 2)Inter turn fault 3)Overloading 4)None of the above

1 Answers   Indian Railways,

How can we calculate D.C.Load current in terms of A.C. load current?

2 Answers  

why 1.7Uo for HV cable Hi pot test?IE standard why?

0 Answers   ABB,

If we have a 2000kva load,How much kvar capacitors we go to add to improve the power factor at 0.9?pls give the calculation and fully theory?

2 Answers   ABB, Unitech,

which is batter in construction job,ELCB or RCCB?

7 Answers   HCC,