Answer / gunasekaran

ohms law applicable only for constant temp but in this case
it is not constant so it is not obey

Answer / surender rawat

Ohm's law applies to conductors whose resistance is
(substantially) independent of the applied voltage (or
equivalently the injected current). That is, Ohm's law only
applies to the linear portion of the I vs. V curve centered
around the origin. The equation is too simple to encompass
devices described by a more complicated I vs. V
relationship.

The basics are neatly given and can be accessed through
following URL http://www.ndt-
ed.org/EducationResources/CommunityCollege/EddyCurrents/Phys
ics/currentflow.htm

Answer / nishant

In a step up transformer we step up the voltage and reduce the current but ohm"S law say V=IR or voltage is directly proportional to current then howz it possible...?

Answer / jawad

regarding your answer,if i step up voltage at primary
side,then current step down,while resistance of the winding
remain same.....then how would u answer it?

Answer / rajasekhar

no,
ohms law works for transformer.bu i donno how u r saying
that inductor is non liner and another thing is that how u
r saying that ohms law is applicable only for resistive
loads?

Answer / kavin

Ohm's law states that V is directly proportional to I for a
constant temperature.But in a transformer is the
temperature constant? NO.Due to joule heating effect energy
is lost as heat and hence temperature changes.Thus ohm's
law is not applicable for transformers.
thank u
kavin

Answer / prosenjit majumder

Ohm law is applicable only for DC . But a transformer acts
on AC only . That is why a transformer does not obey ohm
law .

What is the Power factor of DC Power system ?

9 Answers  

what are the units of cable insulation?

3 Answers  

if single phase is having 220v supply then why three phase is having 440v instead of 660v?

4 Answers   C&S, NTPC,

What is the control action?

0 Answers  

I have 800 Amps MG Fix type breaker It is in on line & it has been given only UV (under voltage)coil connection for tripping purpose.now it is not working properly means its getting tripp so how can i replace it or how can i rectify the problem without destrubing my load??????????

2 Answers  

In power point wiring,often,we use less size of earth wire compared to phase & neutral wire and we use big size pin in pug top. how is it justified? can we use small size cable for earthing?

3 Answers   HAL,

in 220/132 substation in place of PT what equipment used & what r the role of that equipment

2 Answers  

hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....

0 Answers  

Which standard i will refer for size of earthing conductor for equipment? (Eg:415V Switchgear, MCC, DB shall be 50x6mm GI flat)

1 Answers  

What are the different condition monitoring techniques for a motor?

1 Answers   DAE,

how to select a capacitor, i mean we use 3.5 mico ferad cap for a celling fan,but how to select a cap for 1h.p motor,etc.........

1 Answers  

What is the capacitance values of 132,220,400 & 765 kV current transformer

0 Answers