Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nishant
In a step up transformer we step up the voltage and reduce the current but ohm"S law say V=IR or voltage is directly proportional to current then howz it possible...?
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
difference between power surge and switching transient
How cmd is calculated in case of energy neters
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is the need for a controller?
What is notching in dc machine?
work of choke in florocent tube circuit ?
What does the letter CTNM in negative phase sequence relay means?
What are the basic elements used for modeling mechanical rotational system?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
132/66kv sub-station procation ?
What are the significant parts of dc generator?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
why core is useful for a transformer ?and also in its operation ?
