Answer / balaji

In electrical regulator by using resistance the output
voltage is varied simultateneouly the speed is varied...
But to reduce the the energy loses in the resistor,
electronic regulator is introdueced,which uses triac to
vary the output voltage by varing the firing angle.Which
avoids lose of energy in resistor...

Answer / ayyappss

Conventional fan regulator works by the principleof
auto-transformer.
now in modern regulators we using triac to control i.e,by
varying the firing angle, output voltage is varied then
automatically speed can be varied

Answer / saurav

The circuit works by varying the firing angle of the Triac..
output voltage is varied then automatically speed can be varied by this..

Answer / bhanu gupta

Fan regulator working based on the principle of power control using a Triac.The circuit works by varying the firing angle of the Triac . Resistors and capacitor are associated with this. The firing angle can be varied by varying the value of any of these components. Here register is selected as the variable element . By varying the value of register the firing angle of Triac changes (in simple words, how much time should Triac conduct) changes. This directly varies the load power, since load is driven by Triac. The firing pulses are given to the gate of Triac using Diac.

Answer / nk

Electronic fan regulator is an electronic device consisting
of diacs, triacs, potentiometric resistance to provide
stepless control of fan speed. This is an energy saving
device and has advantages over the conventional type of fan
regulators having more energy losses.

These regulators can also be used as a speed regulator for
many other small F.H.P. motors used in mixer, laboratory
solution mixer etc.with appropriate current ratings.

Answer / vatsalsharda

by changing the number of turns,flux linkage changes and
thus induced emf changes

2. What are the parameters of EHT sub-station?

1 Answers   APGenco, Blue Star, Enercon,

WHY TRANSFORMER RATING IS MENTIONED IN KVA RATHER THAN KW

5 Answers  

Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in

1 Answers   HAL,

what is the formula to calculate the distance between one phase to another phase in single phase line and 3 phase line for different volt for example ; 33kv, 11kv ,22kv,230v

1 Answers   Suzlon,

why we are using in reverse power relay in generator singranizing

1 Answers   Dalkia,

what is difference bwt active&passive component

1 Answers  

1)Why V cross Arm is used in transmission lines? 2)Why H cross Arm are not used in single poles?

1 Answers  

is there any chance to get shock from the transformer oil at the time of maintenance due to its dielectric property. . ?

6 Answers   Bhel,

how the direction of rotation in a dc shunt motor could be reversed?

2 Answers  

If rotor works in clock wise what happens

1 Answers  

why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain

1 Answers   ISRO,

why bucholtz relay placed inclined in transformer?

1 Answers