why we are using panel space heaters in different control schemes????

why we are using panel space heaters in different control
schemes????

Question Posted / ranga2k8

3 Answers
10837 Views
Mecon, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we are using panel space heaters in different control schemes????..

Answer / abhishek

panel space heater is used for removing the moisture due to
which insulation breakdown may occur

Is This Answer Correct ?

17 Yes

2 No

why we are using panel space heaters in different control schemes????..

Answer / ilononurb

panel space heater is used to drying up the moisture
entered in the panel to avoid surface leakage current which
may affect the insulation dielectric strenght of the
insulator failure that may cause of series and shunt fault
in the system.

Is This Answer Correct ?

8 Yes

2 No

why we are using panel space heaters in different control schemes????..

Answer / xyz

PANEL SPACE HEATERS ARE NOT A MUST THESE ARE GENERALLY
PROVIDED IN EUROPEAN COUNTRIES AS THIER CLIMATE IS VERY
COLD AS COMPARED TO OURS.BUT AS WE ARE INDIANS WE BLINDELY
TEND TO FOLLOW THERE CONFIGURATION AND SO WE DO........EVEN
IF NOT NECCESORY AND THATS WHY THIS WAS ASKED............

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

WHAT IS counter flux IN CT?

0 Answers

What is an iron loss or core loss pi?

0 Answers

In a circuit a capacitor (paper capacitor ) was burned due to over voltage in this case can we replace that type cappacitor with other tye capacitor ?

1 Answers

WHY SEPARATELY EXCITED MACHINE NEEDS EXCITATION BY DC SUPPLY WHY NOT BY AC

0 Answers

what is the difference b/w permitivity and permeability

1 Answers

What does a Bode plot tell you?

0 Answers GE,

What is it mean Transformer 100/133MVA Power Transformer, significance of 100/133 MVA and 230/115KV please

3 Answers

What is the Ohms low calculation

2 Answers

What is PEC??Applications........

0 Answers Emerson,

How earthing of switchgear system to be done.

0 Answers KSEB, L&T, Siemens,

on 22.03.2015 at 17:15hrs Y phase 66kV class Power Trf-2 Current transformer has flashed over and oil came out. The failed CT has been replaced on 24.03.2015 at 13:15hrs and the Trf has been charged in presence of RT Hassan after conducting the pre-commissioning tests. On the same day at 17:00hrs the commissioned CT has again flashed over and immediately the Trf has been isolated from power supply. It is confirmed the secondary is not opened and checked the earth integrity and is found ok. Here what would be the reason for the CT failure?

2 Answers

what is the ambient temperature of transformer oil & winding?

2 Answers Reddy Labs,

For more Electrical Engineering Interview Questions Click Here