Answer / rvg

Both ,meters will work satisfactorily.

Answer / guest

yes

Answer / dilip kumar

ofcourse both will work satisfactorily ,but if the
connection is used for measurement of 3-phase power then it
will nither give the correct power nor the correct phase

Answer / jack

surely work
but error in measurement

Answer / karthik

yes, if the the 2electronic energy meters are connected
under the same distribution substation it will work, but if
the 2 energy meters are connected in diffrent substation it
will not function properly, becuse neutral only carrying
return current for the single phase loads, if u connect
your elcb getting trip.

Answer / thirumoorthy

It is assumed that it amounts to measurement of two phases
of power measurement by two single phase energy meters. Then
the meters will work satisfactorily but sum of two will not
give total power

Answer / guru

No, when using the electronic energy meters the neutral
should be seperately connected and not a looping.

For example if any fault currents occur in any one of the
phase both the energy will be recorded.

Secondly and main point is electronic energy meters work on
the principle of taking the higher current reading ( Either
it may be in phase or neutral) so if 02 neutrals connected
in loop the sum of the neutral current on both the circuits
will be recorded and the energy value will not be right one.

Answer / raj varpe

yes as the required input is provided to both energy meters
they will work satisfactorily but they are not usable to
measure 3-phase power correctely

WhY PF low at Time of PT Missing in HT Meter

2 Answers   HCL,

what is the need of capacitor in transmission lines?and how it works.

2 Answers   SCCL,

Why are the laminations insulated from each other?

0 Answers  

How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.

2 Answers  

sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.

0 Answers  

hi if anybody got model questions for cpcl Grade'A' electrical engineer position.send it to my mail please krishkumar22@gmail.com

0 Answers  

why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.

1 Answers  

when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)

0 Answers  

What is diversity factor in electric installations?

0 Answers  

Refernce currents are to be generated using refernce cueernts how can this be done

0 Answers   ABC, Wipro,

how can we solve the RMS value of alternative Qnty is .707 , explain detail .

2 Answers  

Whats the type of current and potential transformers?

3 Answers