Answer / sharafuddeen

AS PER IEEE 400.1 ,THE DC TEST VOLTAGE SHOULD BE 100KV FOR
A 35 KV CABLES.AND THERE IS NO A PARTICULAR FORMULA TO
CALCULATE THE TEST VOLTAGE.IT SHOULD BE AS PER THE
STANDARDS AS PER WHICH THE CABLES MANUFACURED.

Answer / ganesh

AC High voltage Insulation test : 132KV for 5 Minute.
IR test to be conducted before and after the AC high
voltage insulation test - 5KV DC for one Minute

Answer / sumit salunke

we are cheking only lekage current of cable
applicable value of voltage of 33 is should be 27kv dc

Answer / ttrrail

AS HI POT TEST IS CONDUCTED IN DC, 25 KV SHOULD APPLY TO
THE 33 KV CABLE

BECAUSE

33KV X 0.707(RMS VALUE TO AVG VALUE CONVERSION) = 25KV(OPPR)

Practical applications of series connected resistances? 

1 Answers  

---

Difference between on line capacitor and Station type capacitor

0 Answers  

---

How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540

0 Answers  

---

A 6.6 KV/ 440V Xformer. what are the imporatant parts & equipment required for it's protection panel.

0 Answers   APTransco,

---

If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.

0 Answers  

---

whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11

0 Answers  

---

why we use crushed stone in switch yard?

3 Answers  

---

Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.

0 Answers   GE,

---

why should series motor be started with load and shunt motor should be started without load??????

7 Answers  

---

how sensors are working?

1 Answers   Amazon,

---

WHAT IS M.P.C.B

3 Answers  

---

what is anode and cathode??

5 Answers   Bombardier,

---