Answer / Pradeep Kumar Bhati

Determining the number of steps (N) and Kvar rating for an Active Power Filter (APFC) panel can be done using the following general steps:
1. Calculate the reactive power needed by the load (Q_load = sqrt(3) * V_L * I_L * sin(phi_l)) where V_L is the line-to-line voltage, I_L is the current, and phi_l is the power factor angle.
2. Determine the maximum active power (P_max) that the APFC panel can handle (P_max = S_APFC / Power Factor). In this case, S_APFC = 40 kvar and Power Factor = 0.8540
3. Calculate the Kvar rating of each step using Kvar/step = Q_load / N.
4. Determine the number of steps (N) required to meet the reactive power demand without exceeding the maximum active power limit (P_max).

description with working of all parts of a Diesel generator???????

1 Answers   DELL,

---

Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?

1 Answers   WCC,

---

How to increase the kvah ?

1 Answers   IGP,

---

1> what r different types of fault in cables? How will u locate and test these faults? 2> why earth wire is provided on top throughout the transmission line. why not only on towers? How much area it can protect? 3> what r different types of transmission losses? How power loss can be minimized? 4> what is the % of power loss on transmission lines?

3 Answers   IOCL,

---

circuit breaker is ...............connected with circuit

2 Answers   Rancho,

---

Will a bulb glow if we connect it between the phase and earth instead of earthed neutral?

3 Answers  

---

why v use only sodium bulb or orange color lights on streets, y nt CLF OR TUBE LIGHTS

3 Answers  

---

Why is transformer core is earthed

3 Answers  

---

why current is constant on d.c?

1 Answers  

---

why transmiision rating in kva?

4 Answers  

---

how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

1 Answers  

---

we all know that in transformer, voltage and current are inversely related i.e. Vp/Vs= Is/Ip....so in standard CT..we have a ratio of 200/5...that means our voltage should increase by ratio of 40..althoug that is not the case...because that requires high insulation level.and pratically not feasible......can anybody clarify my ques.......thanx

2 Answers  

---