How will you separate Colorless compound Using Column
Chromatography?
Answers were Sorted based on User's Feedback
Answer / loges
in colourless compond seperatiion each 100ml fraction
collected seperately and using Thinlayer chromatography
check the seperated fraction by using UV lamp
Is This Answer Correct ? | 29 Yes | 2 No |
Answer / dipti
i colomn chromatograph, if colorless compound has 2
seperate then, another compound is used which is colled as
coloring compound, has the ability to give color with the
compond has to detect.
Is This Answer Correct ? | 28 Yes | 9 No |
Answer / trevor molyneux
There are number of possibilities for identifying the
eluents from the column. Try passing the eluent through a
UV beam if any of the eluents fluoresce. You could also
pass the eluent through a set up with an IR source and
detector or a refractive index measuring instrument. Any
of these alternatives could be used quantitatively.
Is This Answer Correct ? | 5 Yes | 3 No |
Answer / k.madhu
WE R SEPERATED with hptlc method and some pigments is
present so i seperate colorlees
Is This Answer Correct ? | 5 Yes | 16 No |
How to calculate signal to noise ratio by this formula 2H/h where h from where and how to measure
what is the maximum flow rate in prep hplc
What is the meaning of 624 in DB-624 Capillary column used in GC?
how require to fix the linearity and accuracy cincentration range?
why we get only one peak in assay by hplc but in rs by hplc get more peaks
What is control room temperature and which guide line says?
What is the diff b/n OVI and Residual solvents
2. Two grams of Benzoic acid are dissolved in 200 ml of water and extracted with 200 ml of diethyl ether. The distribution coefficient of benzoic acid is 100, and its dissociation constant is 6.5 10-5. Calculate the distribution ratio (D) of benzoic acid at pH 2, 5, and 6. 3. Calculate D at pH 2 to 10 (1 unit apart) in the above problem, and plot D versus pH.
what is principle of XRD?
Why use in sodium salicylate in uv lamps calibration
1 Answers Auctus Pharma, Reddy Labs,
how ir specrometer is calibrated ?
What is differences between normality and molarity.in which cases both are used?