I am mechanical engineer,I need Training in Electrical & Electronics ( i.e

I am mechanical engineer,I need Training in Electrical &
Electronics ( i.e. three days workshop training ) Where
will I get the same Please suggest?

Question Posted / mss

2 Answers
4741 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I am mechanical engineer,I need Training in Electrical & Electronics ( i.e. three days worksho..

Answer / ssk

Try to areva chennai. there u get mechanical,electrical and
electronics knowledge. it is very useful to ur carrier

Is This Answer Correct ?

1 Yes

3 No

I am mechanical engineer,I need Training in Electrical & Electronics ( i.e. three days worksho..

Answer / sunil

OHM energy management (india)pvt ltd

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

Dear all, Can anybody tell me that how to choose CT for a specific load? I have a 200kw induction motor, which ratio CT should be installed? Is there a formula or calculation that determines the CT ratio for a load? Regards.

2 Answers

why we r using alternator instead of d.c generator and induction generator

1 Answers

give types of Air conditioners commonly used &its use?

5 Answers

whats happen if we disconnect the NGR of alternator in running condition?. Generally we observed that transformer netrul is directly grounded but alternator connected with NGR, then ground?

1 Answers

how calculate gd2 of ht motors

0 Answers Hindustan Copper Limited,

We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers

EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.

0 Answers

in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?

0 Answers

what is hormonics. how it is generated & what are the problem faced by that.

5 Answers APC,

how to measure winding resistance of single phase motor?

1 Answers Adani, Dodsal,

How can ignition voltage of light increased with the help of a ballast

1 Answers

do we people experience any shock if we catch any one of the three phases (R Y B)in air with out touching ground.

7 Answers

For more Electrical Engineering Interview Questions Click Here