can anyone tell free downloads website for fundamentals and
principle of basic pressur,temperature,level and flow
Answers were Sorted based on User's Feedback
Answer / welcome4ujd
There are many sites
http://www.spiraxsarco.com/resources/ou-redirect.asp
Go toomega.com and see free litereatures download
transactions all volumes , ur net sholdneed good speed .
http://www.omega.com/literature/transactions/
I think this will be enough
| Is This Answer Correct ? | 5 Yes | 0 No |
pressure gauge measure static pressure or dynamic pressure?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )
What is the role of Integral in pid control?
what is the difference betwwen the 2wire level transmitter and 4wire level transmitter??and their applications also??
Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what will happen if transmitter wire get shoted?
what is the meaning of GK value(fullform) in flowmeter ?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
why we are using magnet for calibration of gas detector?
What is fault tolerent system
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)