what is the differnce betweeen hart and smart tx

3 Answers  

---

Why DP level transmitter preferred for closed vessels and Radar level transmitter for open tanks??

2 Answers  

---

My flow transmitter range is 0-1000mmwc.DCS range is 0- 100m3/hr.What is correspond out put in terms of milliamps if my flow is 65m3/hr

4 Answers  

---

what is control valve input and out put

10 Answers   Nirma,

---

how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???

0 Answers   Siemens,

---

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,

---

how bolometer is used in temperature measurement ??

1 Answers  

---

1)What is the suitable MOC for flow meters working at temperature between 200 - 250 cen. 2)In which application the mass flow meters are not advisable 3)Is it advisable to use radiation type or radar type instrument for non contact application

1 Answers  

---

if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?

1 Answers  

---

what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?

0 Answers  

---

What is the use of +/- 20ma in analog measurement,and which instrument gives +/-20ma output

1 Answers  

---

how to define range of dp level xmeter in open tank

1 Answers  

---