Answer / rabso

The same.

Answer / rakeshsingh41

phase to phaes voltage 440v
line to line voltage is 220v

Answer / omprakash

phase to phase voltage 415v equal to line to line voltage

Answer / omprakash

phase voltage to phasevoltage is 1/1.732
line to line voltage is 1*1.732

Answer / omprakash

phase to phase voltage is 440v equal to line to line
volatage

Answer / durgaprasad

phase to phase voltage is 415.
lineto line voltage 11kv

how we calculate the motor rating of pump for water suction ?its any formula for that plz give thank u

3 Answers  

What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?

0 Answers   ITC Infotech,

i am swathi, b.tech 4th year. In smps(switched mode power supply)we are using diodes,mosfets,igbts for controling of current. And my question is why we did not use thyristors(scr)? it is also act as a switch,then what is the drawback of scr as compared to above transisters> if we use the scr,then what is happening ? plz give reply as soon as possible bcoz i am doing project on smps. plz frnds i want ans for that. if anybody know the ans plz send to my e-mail id /swathi.tadakapally@gmail.com/

5 Answers   EEE, TCS,

what is 2 phase motor?

4 Answers  

what is megar testing

4 Answers   NASA,

What is Ton Capacity of Air Conditioner?

1 Answers   TATA,

What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?

0 Answers   Honeywell,

In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?

0 Answers  

What is the rating of your capacitor bank at your company.

36 Answers   Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory,

What is diversity factor and how to calculate it

2 Answers   Al Faraa, Amul, Pentagon, Sobha Developers,

For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.

3 Answers  

Why we check only first column of root locus..?

1 Answers   IES,