What is the reason for not giving very High Proportional Gain Kp in PID Controller?

2 Answers   ABB,

---

what is diff between the centrifugal and reciprocating

2 Answers  

---

What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers  

---

what should be the attitude while answering an interviewer?

2 Answers  

---

whats the working principle of level transmeter?

6 Answers  

---

WHAT IS A CALLIBRATION? WHAT IS MEEAN BY LOOP CHECKING INCLUDES PRESURE, THERMOCOUPLE,TT,DT?

5 Answers  

---

Explain Difference between Bech set and operating range of control valve

3 Answers  

---

What is the IEC Standard for PLC I/O Terminal wiring Procedure?

1 Answers  

---

there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.

1 Answers   GATE,

---

In 16' pipeline one pcv is installed which is controlled by PT installed at inlet of PCV.If Flowrate in pipeline increases what will happen to pressure at the inlet of pcv.

5 Answers   Essar, vssc,

---

dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.

0 Answers   CPL,

---

Dear friends, I have a question: We work on a project which has some boilers to provide steam for desalination unit. The boiler area is safe and the only hazard source is the fuel lines of boilers. I want to know according to NFPA standard which type of instrument should be selected on the fuel line: Eex Type or Non-Eex type? Thanks in advance

2 Answers  

---