Answer / sudhanva madhukar mahamuni

Mr. Amir Sharif
Mr. Ravi Siemens say that CT is step up transformer thats 100% rigth. Brief : Consider Primary winding as busbars having hundred / thousands of current and secondary as CT winding which have low current at its output and high voltage at its terminals. Hence its called as step up transformer. If CT terminals gets open then self induced emf will cut to its own winding i.e. CT and it will be uncontrollable and hence due to high voltage its insulation gets damage and CT will get burn.

Thanks to Siemens Mr. Amir Sharif is not there in SIEMENS.
Mr. Ravi keep going on dont upset due to such ans.

Mahamuni

Answer / amir sharif

Dear Sudhanva Madhukar Mahamuni,

I think you did not see Ans# 11 . Please see it and you ll come to know .

Moreover thanks for the Brief up and FYI ...Mr Amir Sharif is also in siemens ..lolz ..Thanks to siemens haan ...U can reach me in amir.anvar@siemens.com . Mistakes tend to happen as we all r human beings ...Hope you get that

Answer / amir sharif

Mr ravi siemens ..........CT doesnt step up ....it steps
down and its for metering ......u r lucky to b there in
siemens .....

Answer / v.selvakumar

if ct opens during heavy load , heavy voltage will appear
across ct secondary ,because of no oppossing emf present
primary.result ct will blast

Answer / dinesh kumar

There are two types of Cts
1.ACCT
2.DCCT
In ACCT if secondary is open during load it will damage the
CT due to high current ratio.
2,In DCCT the secondary is Equipmentload,ie,Bus bar

Answer / vinothbhabu.k

ct is a controling device for both the primary and
secondary,if secondary opened means the current ratio will
be losed and also equipment connected in the secondary side
will be sever damaged.

What is CBCT ? Why & Where it is used?

14 Answers   BCT,

what is the name for a meter/tester to measure the paint quality in electrical panel or wall?

1 Answers  

why is used for starters for staring motors?

6 Answers   Amrapali, L&T,

why grid failure happens?

1 Answers  

What is the difference between rated and maximum speed of 3phase induction motor.....? Can the motor speed exceeds the rated speed..?

1 Answers  

what are the causes for strip heater failure ?

1 Answers  

How much ph is maintained of water resistance starter for slipring induction motor ?

0 Answers  

There is two transformers of 2MVA & 3MVA, which transformer is located at the sending end & which is at receiving end. why?

3 Answers  

Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.

0 Answers  

Technical equations

1 Answers   ME,

what is the basic construction diffrance between servo motor ans sqiralcage induction motor

0 Answers  

I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????

0 Answers