Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN WHEN CT SECONDARY OPEN DURING LOAD
- 16 Answers
- 32204 Views
- Neco, I also Faced
- E-Mail Answers
Answer Posted / vinothbhabu.k
ct is a controling device for both the primary and
secondary,if secondary opened means the current ratio will
be losed and also equipment connected in the secondary side
will be sever damaged.
| Is This Answer Correct ? | 1 Yes | 13 No |
Post New Answer View All Answers
what is the chiller and working principal
Electrical 'C' license full abbreviation , and full form
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
how to calculate the loss tangent of electrical cables
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
WHAT IS THE DIFFERENCE BETWEEN AN ACB & mccb 7 WHAT IS THE CRITERIA WHEN TO USE WHICH OF THE TWO
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
can the measured percentage error during calibration of single phase energy meter be negative?
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
state types of reflectors in illumination engg. ???????
While testing a ZCT what parameters have to check or measure?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
how to estimate wiring ins roughing ins. and boxes
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
what is maxemo work permit procedure
