There is two transformers of 2MVA & 3MVA, which transformer is located at

There is two transformers of 2MVA & 3MVA, which transformer
is located at the sending end & which is at receiving end.
why?

Question Posted / ganesh mahjan

3 Answers
6599 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

There is two transformers of 2MVA & 3MVA, which transformer is located at the sending end &..

Answer / raji g

3 MVA TRANSFORMER IS IN SENDING END
2 MVA TRANSFORMER IE IN RECEIVING END

Is This Answer Correct ?

13 Yes

0 No

There is two transformers of 2MVA & 3MVA, which transformer is located at the sending end &..

Answer / elaiyaraja

always the sending end transformer must have higher value
then receiving end . bcoz if load suddenly increased it can
able withstand the sudden demand...

Is This Answer Correct ?

6 Yes

1 No

There is two transformers of 2MVA & 3MVA, which transformer is located at the sending end &..

Answer / manoranjan mishra

always higher rating TRF is installed at sending end &
lower rating is in receiving end because higher rating TRF
load capacity is more than lower rating TFR.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Explain Continuous and Discrete signals?

0 Answers UOG,

what is saturation? what role it plays in operation of ct's,motors etc and how its affects the behaviour of the same.

1 Answers

what is the sweep commenly used 1200mm sweep and 600mmsweep please tell me breifly sweep

1 Answers Khaitan,

Whats the use of earth pits? and it will function? whats the natural earth value? How to improve ur earth resistance?

3 Answers Anwar Ispat,

with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen

0 Answers

Just a silly question but just to make my curious mind bac to normal - Why was not 67 and 67N relays built into a single relay as i have noticed that the R,Y,B CT wiring end up into the 67 relay while the common of the R,Y,B CT wiring end up into the 67N relay. Then it was better if a single relay was manufactured just like the distance relay (21). Another question i would like to ask is - how do we know where the 67 and 67 N relay has to be placed.why is it not placed at the transformer bay? In the substaion that i am working -i have noticed that it is placed between a breaker and a common double bus bar and this line bay is connected to another substation at a remote place which is furthur connected to a load. B U S______CT for 67 & 67N ______Breaker _____ remot s/s. B A R

1 Answers

What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers

i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.

0 Answers

to improve the existing power factor whether capacitors have to be added in series or parallel.and why

3 Answers

how many types of transformer.

3 Answers Technocrats,

how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt

0 Answers

State the methods of improving power factor?

0 Answers

For more Electrical Engineering Interview Questions Click Here