Answer / shobana

Electrical: It deals with power generation, transmission,
distribution & utilization of electrical energy at high
efficiency.

Electronics: It deals with distortionless production,
transmission and reception of datas and signals of milli
watts to few watts without considering much about
efficiency.

Answer / shailesh nimkar

generation,transmission,distribution on high level is yeild
an electrical
transmission,distribution,utilisation on low level is yeild
electronics
by using semiconductors controlling electrons or elecrical
energy is called electronics

Answer / bivas hazra

electrical deals with high voltage & high current on the
other hand electronics deals with low voltage & low current.

Answer / venkatesh v.r.

1.generally we consider electrical with high voltages like
kv's but in electronics only low ac and dc voltages
2.maximum we use conductors for electrical but in
electronics we use pcb's(printed circuit boards)

Answer / saurabh

The term electrical engineering may or may not encompass
electronics engineering. Where a distinction is made,
electrical engineering is considered to deal with the
problems associated with large-scale electrical systems
such as power transmission and motor control, whereas
electronics engineering deals with the study of small-scale
electronic systems including computers and integrated
circuits.[1] Another way of looking at the distinction is
that electrical engineers are usually concerned with using
electricity to transmit energy, while electronics engineers
are concerned with using electricity to transmit
information.

Answer / fireprs

Electrical deals with High Voltage & Current whereas
Electronics deals at lower voltage & current

Answer / anonymous

above 25V is electrical.
both uses the same equipments for eg. resistances,
capacitances, only the ratings differ as v hav diode in
electronics but power diode in electricals.

Answer / kumavat nareshkumar .c.

ELECTRICAL:Flow of current in conducter(Al,cu etc.) and in
this contain power station equipment,transmission line and
SIZE is high,RATING is high.
ELECTRONICS:Flow of current in semiconducter and in this
contain thyrister,diac,triac,chopper,SMPS,UPS etc. and SIZE
is small,RATING is low.

Answer / mohan

electrical means which works on AC voltages(220v to 250v),
ex; fan,transformers

electronics means which works on dc voltages(110v dc)
ex:computers,laptops,mobiles mohan.burra@gmail.com

Answer / prabakaran ks

Electrical mean flow of electrons through the conductor

Electronics mean flow of electron and hole ( +ve,-ve charge ) through the semiconductor

advantages of vvvf drives over non vvvf drives for EOT cranes

2 Answers  

Derive the inductance of a coil in terms of its physical factors.

1 Answers  

Does Lightening arrest requires Earthing?..

5 Answers  

In India,we use 230V,50HZ,where as many other countries use 110V,60HZ what r d advantages and disadvantages of each of them?

8 Answers   GVK,

what is the function of Choke?

9 Answers   Airport Electrical, Cummins, Tamco,

why in some cases the receiving end voltage is higher than the sending end voltage in transmission line (called 'Ferranti effect') ????? whts the reason behind tht???

3 Answers  

Waht will happened if reactive power increase in the line? waht about active power increase too?

3 Answers  

How to calculate that clean water supply in one Day from 150 KLD STP?

0 Answers  

what is meant by motor startup supervision & motor load jam protection ?

0 Answers   ABB,

IF ANY MATERIAL AVAILABLE IN MARKET FOR MOTOR PROTECTION INSTEAD OF OLR & CONTACTOR ?

1 Answers  

why are we using resistor in NGR ?

1 Answers  

i) in which cases should we go for neutral and where should we go for ground? ii) in domestic supply we are getting 230v a.c.and what is the amount of current?

2 Answers