Answer / saravanan

phase is a sending path& neutral is a receving path

Answer / prasad

In power system 3 phase supply with star connected winding
is used for supplying to single phase load. The star point
is called as Neutral since in perfectly balanced system the
voltage & current at neutral is zero.
In single phase load, the phase is supplying current while
return path for current is provided by neutral which is
basically other end of that phase with voltage almost equal
to zero

Answer / praveen

phase is a wire which supplies actual electricity i.e.,
current and neutral wire only gives path for current to
return in single phase supply.....

Answer / priyadharsini

current passes only when a closed circuit is present.
here neutral is act as a return path. ie why neutral
conductor is half of the phase conductor value.

another information is that.

phase only have the fuse. neutral having neutral link.bcoz,
the equipment should protect before the fault current
reaches it. if we provide fuse in neutral fuse blows after
gone thro the equipment to be protected. bcoz neutral is a
return path

Answer / ravi prakash

IN AN ELECTRICAL AC CIRCUIT PHASE IS IN HIGHER POTENTIAL AND
NEUTRAL IS IN ZERO POTENTIAL.LOAD IS CONNECTED BETWEEN PHASE
AND NEUTRAL.

Answer / vindhya vasini

to identify phase and neutral in a star connection phase is simply a winding or coil and neutral is a point where these windings meet neutral is a receiving end
the voltage across phase is known as phase voltage (Vph) and current across phase is called phase current (Iph)

Answer / vijay

phese wire indicate a voltage phase and earth but nutral
and earth indicate a diffrece a voltage zero

What are the Safety Steps While Inspection the LT Panel.  

1 Answers  

How to size the Neutral grounding resistor?

1 Answers  

why three phase three wire system probably did'nt have neutral

2 Answers   Marico,

How to select the different contactors ( starter combination) for different AC motors? what about fuse cappacity 4 different motors too?

2 Answers   Equate,

What is the difference between earth and neutral

4 Answers   ABB, Tamboli Engineers,

how power can be saved using VFDs in detail explain

1 Answers  

Why we use a H.T. Fuse from a thick wire, on other side we use high rating of cables? & Why we use less Sq. mm Cable on H.T. side , on other side we use Large Sq. mm cable?

1 Answers  

differentiate PLC,DCS,SCADA?

1 Answers   SAS,

WHY LINK NOT A FUSE IN AC CIRCUIT

3 Answers  

How to test REF relay testing for LV panel as per Kahramaa standard?

0 Answers  

Explain the operation of damper winding

2 Answers  

What is the most essential condition for the voltage build up for a d.c. Shunt generator?

0 Answers