Answer Posted / praveen
phase is a wire which supplies actual electricity i.e.,
current and neutral wire only gives path for current to
return in single phase supply.....
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
What is a signal flow graph?
what is mean by descripiency relay? & wht is its ansi code?
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
What will happend if given Vfd out put to step up transformer
How to calculate impedance volt in Transformer?
What is the difference between amorphous core transformer and CRGO core transformer?.
On what basis the the size of Lightning arrester for buildings are selected ?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
How can we measure the residual voltage in dc machines?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.