Answer / prashant

frist click on reflash and wait for 20 minute, and touch
screen calibation in one time, then hart boot up in auto.

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 - 50 mbar abs by hand pump calibrator.

4 Answers   Bharathi Cement,

---

Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?

4 Answers   Ecil,

---

How to check vortex flow meter is in good condition while we do not having calibration setup?

4 Answers  

---

what type of cables are used for f&G systems and detectors, what is the standard colour?

2 Answers   Punj Lloyd Ltd,

---

what does mean by analog output trim and where this one used for?

1 Answers  

---

suppose, after calibrating a transmitter we fixed it in a process line. At live zero condition the Tx shows 4.5 mA. what should we do to make the Tx show 4 mA? If we adjust zero, will it not affect the calibration?

4 Answers   ABG Shipyard,

---

State 5 different method of level measurements.

3 Answers   SRACO,

---

How can I map a tank?  Tank 15m h and 42m dia. we just fixed radar type lit. its reading shows over range. Now its required mapping ?

1 Answers   CMC,

---

how will you segregate the alarm levels in alarm management system during factory Acceptance Test

0 Answers  

---

Why Ma signal is using for control system?

1 Answers   Petrofac,

---

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full load and 80% at no load. How to draw ladder logic.(PLC).

2 Answers  

---

Why only negative 24 vdc supply give in vibration measuring system.

6 Answers  

---