Why injector pressure is used in heavy vehicles?

0 Answers  

---

Interlocking mechanism is provided in the gear box cover a) To prevent engagement of two gears simultaneously b) To prevent engagement of reverse gear c) To facilitate the gear selection d) To avoid the necessity of having neutral gear

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What do you mean by independent suspension?

0 Answers  

---

The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is a pressure cap in the radiator?

0 Answers  

---

---

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

Tell me about a time when you surmounted a major obstacle.

0 Answers   Ashok Leyland,

---

The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the size of the recommended compressor cfm?

0 Answers  

---

What is the engine rating required for 1000 KVA Generator set. Calculations?

0 Answers  

---

what is meaning of 1640 write on the trailor

3 Answers   TATA,

---

what is the three method of heat transfer?give example of each.

3 Answers  

---