on how many points, an engine-clutch-gear box unit is supported on chassis fra

on how many points, an engine-clutch-gear box unit is
supported on chassis frame ?

Question Posted / hmahajanme@hotmail.com

4 Answers
13529 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?..

Answer / ramesh chandra panda

Is This Answer Correct ?

27 Yes

7 No

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?..

Answer / mitesh k. davariya

3 points.

one is resisting rolling of vehicle,
another for resist pitching and last for yawing.

Is This Answer Correct ?

6 Yes

1 No

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?..

Answer / hariprasath

4 in heavy & probably 3 in light.....

Is This Answer Correct ?

2 Yes

0 No

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?..

Answer / rajendiran

Is This Answer Correct ?

2 Yes

6 No

Post New Answer

More Automobile Engineering Interview Questions

How to calculate the speedometer ratio in the vehicle?

0 Answers

Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!

0 Answers OBDmore,

why tractor rear wheel is big then front wheel

2 Answers MAHINDRA,

What is the difference between bs2 & bs3 engine?

0 Answers

What is the difference between Cycle time, standard time & Critical standard time?

1 Answers DICV, Pricol,

Define Hook's law.

0 Answers Ashok Leyland,

difference bitween CPC & SQC

0 Answers Augen Technologies, John Deere, UGS,

If a diesel engine is running at 2500 RPM, How much would be RPM of turbocharger?

0 Answers

SMART PLANT INSTRUMENTATION INtools Training In Singapore

1 Answers

Usually helicopters are having a small fan at the rear end, the purpose is;? (1) To increase it’s lifting capability (2) To balance the torque applied on the main fan (3) For safe landing (4) For safe taking off

2 Answers

Classify Lathes.

0 Answers Ashok Leyland,

Why are i/p transducer connected with 24v dc not to 220v ac?

0 Answers

For more Automobile Engineering Interview Questions Click Here