Answer / Tauseef Ahmad Khan

The Common Probes used in a Oscilloscope include:n- Voltage probe: Measures voltage across a device or circuit.n- Current probe: Measures current flowing through a wire or cable without breaking the circuit.n- Logic probe: Identifies digital signals like TTL, CMOS etc.n- Resistance probe: Measures resistance in a circuit.n- Capacitance probe: Measures capacitance in a circuit.

why and how voltage sharing in transformer, during magnetic balance test ?

0 Answers   ME,

---

is it value of power factor is more than unit. whats effects in the source supply

1 Answers  

---

If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost

1 Answers   ANITS,

---

why do we have spikes enough to burn electronic boards, when generators are not grounded

1 Answers  

---

can we load Power capicitors on DG sets?

14 Answers   Neptune, Nimbus, Westin,

---

how we are desining 63.5 ohm resistor for NGR of alternator?

1 Answers  

---

What is the capacitance values of 132,220,400 & 765 kV current transformer

1 Answers  

---

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers   Siemens,

---

Where earth point should provided in Ships or Submirines.

2 Answers   SSC,

---

Why no-load primary current is very small as compared to full load current in transformer (as 1% of full load current?

5 Answers   NTPC,

---

Supose we have one 220v A.C fan.if we provide 220v D.C what will be happen?

13 Answers  

---

on what factor insulation resistance depends

2 Answers   Uttam Sugar,

---