Can you tell me how we will select RTD and Thermocouples for Temperature applications. I.e How we will choose accurate one for a specefic operation if both having same ranges

3 Answers   Nippon,

---

relation between flow and differential pressure.

7 Answers   ABB,

---

How to define the size of control valve?

5 Answers  

---

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

2 Answers  

---

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers  

---

i have D.p. transmitter of range 0 to 2540 mmWC, i want to use this for flow measurement (0 to 500 ltr/hr.) what should i do?

9 Answers  

---

who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.

2 Answers  

---

what is three element in thermal boiler

9 Answers  

---

how in the 2 - wire transmitter, 24v supply and the 4ma signal gets in the same path?

1 Answers   Yokogawa,

---

why the output sugnal is 4-20 ma and not 4-25 ma?

5 Answers  

---

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

What is electronics?

6 Answers   ITC Infotech,

---